Rjs Inspector D4000 Laser (FIRMWARE version A.05 and E User Manual download pdf (Page 36)

Appendix A Operator’s Guide

RJS, Minneapolis, MN 002-5568

Appendix A (Code 128)

Code 128

Code 128 can encode all the characters currently encodable in the various code formats

presently in existence. This includes: all ASCII alphanumeric characters (numbers, letters,

special characters, control characters in the 128 character set and the distinction of the 3

subsets, A, B and C).

Code subset A includes the standard alphanumeric (upper case only) keyboard characters

plus control and special characters.

Code subset B includes all the standard alphanumeric keyboard characters and special

characters (upper and lower case).

Code subset C includes a set of 100 digit pairs from 00 to 99 inclusive, allowing definition of

double density numeric digits per symbol, plus special characters.

The last 7 characters in Subsets A and B (96 - 102) and the last 3 characters in Subset C

(100 - 102) are special characters that are specific to the scanning device.

The Laser Inspector display can accommodate up to 16 characters. However, in order to

display symbols greater than 16 (maximum of 32), press Select to display the additional

characters.

(See Data Analysis Screens).

Table A-1 shows the encodable code subsets for 128. The Laser Inspector display (in the

shaded boxes) is just below the encodable code 128 character sets.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 80 81

No comments

Rjs Inspector D4000 Laser (FIRMWARE version A.05 and E User Manual Page 36